LZ Lesenz Switch - Bluetooth; Playing Music from USB Disk & Micro SD Card; FM Radio; TWS Function

7. Power ON/OFF 8. Play/Pause 9. Forward/Volume Up
Bluetooth:
1.Turn the power button to “ON”, The LED light turn blue and twinkle quickly,
then enter Bluetooth mode and make a tone “Bluetooth Device Ready To Pair”.
2.Activate Bluetooth of mobile phone and search for device name “LZ Switch”
then connect it. The blue LED light will flash and make a confirmed tone once
connected.
3. Play the music from your mobile phone and enjoy.
4. Press Forward or Backward button on the device or on Mobile phones to
select songs you like.
5. Press Play/Pause button on the device or on Mobile phones to play/pause the
music.
6. Long press Forward or Backward button to adjust volume up and down. Or
adjust the mobile phones’ volume.
Playing music from USB disk & Micro SD card:
1. Turn the Power button to “ON”.
2. Insert Micro SD card or USB flash disk into slot, the speaker will make a tone
“Music Play Mode”, and play the stored music automatically.
3. Under playing mode, short press Forward or Backward button to select songs
you like, long press to adjust the volume up and down.
4. Press Play/Pause to play or pause.
Remark: Under Bluetooth playing mode, insert Micro SD or USB will disconnect the
Bluetooth and switch to play the USB or Micro SD card. You can press the MODE
button to switch to Bluetooth mode again.
FM Radio:
1. Under FM radio state, the audio cable provided treat as antenna. Please
Insert the audio cable to get best FM signal before using.
2. Turn the power button to “ON”, press the “MODE” button, the speaker will
prompt “The Radio Mode” when entering FM state.
3. Under playing mode, short press “Play/Pause” button to auto search the FM
Channel and store it automatically.
4. Press Forward or Backward button to change the stored FM channel.
TWS Function:
1. Turn on two identical speakers you want to pair, please noted they must be the
same BT paring name, both under BT mode. Only need to set up one of the two
units;