Front and Rear Panel Features
Rear Panel
1. XLR INPUT:This jack accepts XLR input connections with either balanced or
unbalanced wiring.The signal of the XLR INPUT is summed together with the
TRS INPUT through a balanced input amplifier, allowing both inputs to be used
simultaneously. Input specifications apply to both inputs.The input wiring of an
XLR connector should be as follows:
XLR PIN 1 Signal ground (Shield)
XLR PIN 2 Signal positive (+)
XLR PIN 3 Signal negative (–)
2. TRS INPUT: This jack accepts a TRS connector, either balanced or unbalanced
wiring. For balanced wiring, a three-conductor TRS plug is necessary.The input
wiring of a TRS connector should be as follows:
TRS TIP Signal positive (+)
TRS RING Signal negative (–)
TRS SLEEVE Signal ground (Shield)
4
To Next Page
Loading...
