EasyManuals Logo

M-Audio DELTA 1010LT User Manual

M-Audio DELTA 1010LT
59 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
Another way to approach this is by directly monitoring those inputs. This can be done in
the Delta Control Panel’s “Patchbay/Router” page by selecting the Delta input and
connecting it directly to the Delta output. You can also use the Delta panel’s Monitor
Mixer to send the signal at the inputs to the Delta outputs, as well as mix those signals
with the software outputs, i.e., your music software sending audio to the Delta outputs.
This, and other recording/monitoring scenarios are covered in the Tutorials section toward
the end of the manual.
Product Features & Specifications
10x10 24-bit/96khz full-duplex recording interface.
PCI host card with two external, color-coded breakout cables.
8x8 analog I/O, balanced on female XLR and unbalanced on gold-plated RCA
connectors, with output line level adjustments selectable within the Delta Control Panel.
The two balanced analog inputs can be set via hardware jumpers to accept
microphone level signals or line level signals.
S/PDIF digital I/O supports a variety of settings, including AC3 or DTS surround
(PC only) and copy protection schemes, which can be set via the Delta Control Panel.
External synchronization up to 100kHz via word clock I/O on BNC connectors.
1x1 MIDI I/O on standard DIN jacks.
High dynamic range (A-weighted measured): D/A 101.5 dB, A/D 99.6 dB.
Low distortion (measured THD @ 0dBFS): A/D and D/A less than 0.002%.
•Frequency Response: 22-22kHz, -0.2,-0.4dB @48kHz; 22-40kHz,-0.2,-0.7dB @96kHz
All data paths support up to 24bit/96kHz performance, no upgrades necessary.
Comprehensive digital mixing, routing, and monitoring capabilities with
included Delta Control Panel software.
Hardware sample-accurate sync will allow linking of multiple Delta units via S/PDIF.
Windows XP, 2000/ME and 95/98 multi-card, multi-client drivers with ASIO1
and ASIO2 multi-card, GSIF and EASI drivers included; Windows NT
multi-card drivers also included.
Macintosh control panel and drivers with ASIO1, ASIO2, and legacy ASIO
support for OS 8.5.1 or higher.
Minimum System Requirements
Windows
Windows 95, 98, NT, ME, 2000 or XP
Pentium III 500Mhz - (96kHz operation)
Pentium II 400 - (48kHz operation)
128 MB of RAM - (96kHz operation)
64 MB of SDRAM - (48kHz operation)
UDMA EIDE
4

Other manuals for M-Audio DELTA 1010LT

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the M-Audio DELTA 1010LT and is the answer not in the manual?

M-Audio DELTA 1010LT Specifications

General IconGeneral
Analog Inputs8 x 1/4" TRS
Analog Outputs8 x 1/4" TRS
Bit Depth24-bit
InterfacePCI
THD+N0.002%
Digital InputsS/PDIF
Digital OutputsS/PDIF
MIDI I/O1 x In, 1 x Out
Software CompatibilityASIO, Core Audio
Sample RateUp to 96 kHz
Channels10 input / 10 output

Related product manuals