7
so that the effects unit is getting the “hottest” possible signal
without overloading. Set the effects unit to output wet
(processed) signal only and use the MicroMixer’s return level
to control the mix of processed and non-processed signal.
When performing live, you can use one of the sends for an
on-stage monitor mix.
Processing Microphone Signals
Since the MicroMixer has no balanced inputs and is designed
to accommodate line level signals, you will need an imped-
ance matching transformer and some sort of mica pre-amp if
you want to plug a Low Z microphone into one of the
MicroMixer’s inputs. If you want to record or process guitars
we also suggest that you use a pre-amp rather than run
direct.
To Next Page
Loading...
