EasyManua.ls Logo

M-Audio Studiophile LX4

M-Audio Studiophile LX4
15 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Appendix A - Technical Specifications
Type: 3-way studio reference with subwoofer (2.1 System), expandable to 5.1
Subwoofer Driver: 8 inch diameter, specially-developed curved-profile pulp
cone, high-temperature voice coil and damped closed cell foam surround -
designed for sub-frequency pressure levels with very high efficiency and
extremely low distortion
LF Driver: 4-inch dia., magnetically-shielded with curved mineral-filled polypropylene
cone, high temperature voice coil and damped closed cell foam surround
HF Driver: 1-inch dia., magnetically-shielded; specially-shaped mylar dome
Frequency Response: 40Hz - 20kHz
Crossover Frequencies: 2.9kHz and 140Hz
RMS SPL @ 1 meter: 105dB
Subwoofer Amplifier Power: 60W
Sat Amplifier Power: 27W (Five Sat Amplifiers)
Dynamic Range: >100dB
S/N Ratio: >100dB below full output, 20kHz bandwidth
Input Connectors: Six TRS balanced/unbalanced input connectors (L, R, SL,
SR, C & LFE)
Polarity: Positive signal at + input produces outward low-frequency cone displacement
Input Impedance: 20k ohms balanced, 10k ohms unbalanced
Input Sensitivity, Sat: Input 100 mV pink-noise produces 90dBA output
SPL @ 1meter w/ vol ctl at max setting
Input Sensitivity, LFE: input 50mV pink-noise produces 90dBA output SPL
@ 1meter w/ vol cntrl at max setting
Protection: RF interference, output current limiting, over temperature, turn
on/off transient, subsonic filter, external main fuse
Indicators: Green-Orange Power/Protection indicator (Back Panel). When
the power switch is switched to ON, the LED will glow “Green”. When the
Protection circuitry of power amplifiers is turned on , the LED will glow
“Orange.At the same time, the output level will reduce 12dB.
Power Requirements: Dual-voltage (selectable by rear-panel switch) for
either 120V/~60Hz, 230V/~50Hz; powered via detachable 3-circuit line cord
Cabinets: vinyl-laminated MDF
Dimensions - L, R, SL, SR & C: 8.5” (H) x 5.75” (W) x 6.75” (D)
Dimensions - Subwoofer: 15.75” (H) x 9.75 “ (W) x 12.25” (D)
Weight - L, R, SL, SR & C: 4.5 lbs. each
Weight - Subwoofer: 21.9 lbs.
* All specifications subject to change without notice
14

Related product manuals