Safety instructions 11/56
RE 93221-01-B/07.2013, A22VG Series 40, Bosch Rexroth AG
WARNING
Danger from suspended loads!
Danger to life or risk of injury, damage to equipment!
Improper transportation may cause the axial piston unit to fall down lead to injuries
e.g. crushing or broken bones or damage to the product.
▶ Make certain that the forklift truck or lifting device has adequate lifting capacity.
▶ Never stand under or put you hands under suspended loads.
▶ Ensure your position is stable during transportation.
▶ Use your personal protection equipment (e.g. safety glasses, safety gloves,
suitable working clothes, safety shoes).
▶ Use suitable lifting devices for transportation.
▶ Observe the prescribed position of the lifting strap.
▶ Observe the national laws and regulations on work and health protection and
transportation.
Pressurized machine/system!
Danger to life or risk of injury, serious injuries when working on machines/systems
not shutdown! Damage to equipment!
▶ Protect the complete system against being energized.
▶ Make sure that the machine/system is depressurized. Please follow the machine/
system manufacturer’s instructions.
▶ Do not disconnect any line connections, ports and components when the
machine/system is pressurized.
▶ Switch off all power-transmitting components and connections (electric,
pneumatic, hydraulic, mechanical) in accordance with the manufacturer’s
instruction and secure them against being switched back on.
Escaping oil mist!
Risk of explosion, fire, health hazard, environmental pollution!
▶ Depressurize the machine/system and repair the leak.
▶ Only perform welding work then the machine/system is depressurized.
▶ Keep open flames and ignition sources away from the axial piston unit.
▶ If axial piston units are to be situated in the vicinity of ignition sources or
powerful thermal radiators, a shield must be erected to ensure that any escaped
hydraulic fluid can not ignite, and to protect hose lines from premature aging.
Electrical voltage!
Risk of injury due to electric shock or damage to equipment!
▶ Always set up the relevant part of the machine/system so that it is free of
electrical voltage before you install the product or when connecting and
disconnecting plugs. Protect the machine/system against being energized.
To Next Page
Loading...