REMOVING YOUR KINDLE: THOROUGHLY DRY OFF GUARDIAN CASE BEFORE
REMOVING KINDLE.
Flip the Guardian Case over so the front is facing down and all four latches are visible.
Release each latch by placing your finger in the appropriate finger notch and
pulling each Tab upward.
Flip the Guardian Case back over and ensure all Latch-Locking Mechanisms are
detached from front.
Open the Guardian Case Front and remove Kindle.
CONTINUED: STEPS AND PROCEDURES FOR PROPER CASE FUNCTION
SECTION II
O-RING CARE AND MAINTENANCE
• ONLY use mildly soapy water to clean.
• The O-ring is NOT Dishwasher safe.
• Do NOT store the O-ring in high temperatures or direct sunlight.
• Do NOT bend, twist, or distort shape of the O-ring. Stretching or augmenting
the O-ring could prevent its capability to form a water-tight seal.
• Make sure the O-ring is installed correctly before every use.
• Replace the O-ring after 1 year. Warranty on the O-ring is void after 1 year.
• Never remove the O-ring with a sharp object.
> For replacement O-rings visit: www.medgeaccessories.com
O-RING CHANNEL CARE AND MAINTENANCE
• Rinse in fresh, mildly soapy water after use and before storing. Never use bleach
or detergents.
• Do NOT store in direct sunlight or high temperatures.
• Keep free of obstruction. Check the O-ring Channel before every use. An obstructed
channel can prevent a water tight seal from forming.
• The O-ring Channel is not designed to withstand trauma from dropping. Do not use and
contact M-Edge customer service if you notice any chips or cracks.
STEPS AND PROCEDURES FOR PROPER O-RING FUNCTION
CONTINUED ON NEXT PAGE
To Next Page
Loading...