M-system LECA User Manual

LECA
P. 1 / 3EM-1945
5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
Phone: +81(6)6659-8201 Fax: +81(6)6659-8510 E-mail: info@m-system.co.jp
INSTALLATION
n DIN RAIL MOUNTING
Set the unit so that its DIN
rail adaptor is at the bottom.
Hang the upper hook at the
rear side of the unit on the
DIN rail and push in the lower.
When removing the unit, push
down the DIN rail adaptor
utilizing minus screwdriver
and pull.
n WALL MOUNTING
Refer to “DIMENSIONS.”
DIN Rail
35mm wide
Spring Loaded
DIN Rail Adaptor
BEFORE USE ....
Thank you for choosing M-System. Before use, check the
contents of the package you received as outlined below.
If you have any problems or questions with the product,
please contact M-System's Sales Office or representatives.
n PACKAGE INCLUDES:
Transducer ................................................................(1)
n MODEL NO.
Confirm that the model number described on the product is
exactly what you ordered.
n INSTRUCTION MANUAL
This manual describes necessary points of caution when you
use this product, including installation, connection and basic
maintenance procedures.
COMPONENT IDENTIFICATION
Span Adj.
Connection
Diagram
Body
Specifications
CT TRANSDUCER
(super-miniature size; self-powered, average sensing, RMS calibrated)
MODEL
LECA
INSTRUCTION MANUAL

M-system LECA Specifications

General

Brand	M-system
Model	LECA
Category	Transducer
Language	English

Summary

Before Use

Package Contents

Lists items included in the package for verification.

Model Number Confirmation

Confirms the model number on the product matches the order.

Instruction Manual Overview

Highlights points of caution, installation, connection, and maintenance.

Installation

DIN Rail Mounting

Instructions for mounting the unit onto a standard DIN rail.

Wall Mounting

Refers to 'DIMENSIONS' for wall mounting instructions.

Terminal Connections

Dimensions

Provides physical dimensions of the unit in millimeters and inches.

Connection Diagram

Illustrates the wiring for signal source and output connections.

Checking

Adjustment Procedure

Calibrate Output Signal

Details steps for calibrating the output signal using a signal source.

Points of Caution

Removing the Unit

Safety precaution: turn off input signal before removing the unit.

Environmental Precautions

Specifies suitable operating environment conditions and precautions.

Wiring Guidelines

Guidance on installing signal and output cables away from noise sources.

Warm-up Procedure

Unit requires a 10-minute warm-up for complete performance.

Maintenance

Regular Calibration

Explains the regular calibration procedure for the unit.

Lightning Surge Protection

Recommends using surge protectors for signal and power cables.