What to do if my Mac allister Cordless Saw suddenly stops?
If your Mac allister Cordless Saw suddenly stops, it could be due to a discharged battery pack, in which case you should remove and charge it. Alternatively, the battery pack might be too hot; remove it and allow it to cool down. Another possibility is that the saw chain is blocked, so you should remove the blockage.
Why doesn't my Mac allister MGS1815-Li Cordless Saw reach full power?
If your Mac allister Cordless Saw isn't reaching full power, it might be because the battery pack capacity is too low, so charge the battery pack. Alternatively, the air vents could be blocked; in this case, clean the air vents.
Why is my Mac allister Cordless Saw making excessive vibration or noise?
If your Mac allister Cordless Saw is producing excessive vibration or noise, it could be due to several reasons: * The saw chain might be dull or damaged, requiring replacement with a new one. * The bolts or nuts may be loose, so tighten them. * The chain oil might be incorrect, so use the correct oil.
How to troubleshoot a Mac allister MGS1815-Li that won't start?
If your Mac allister Cordless Saw does not start, ensure the battery pack is properly attached. If it still doesn't start, the battery pack may be discharged (remove and charge it), too hot (remove and let it cool), or damaged (check by a specialist electrician). There may also be another electrical defect to the product, so it should be checked by a specialist electrician.
What to do if my Mac allister MGS1815-Li Cordless Saw gives an unsatisfactory result?
If you're getting an unsatisfactory result with your Mac allister Cordless Saw, it could be because the saw chain isn't tensioned properly, so tension it properly. Alternatively, the saw chain might be dull or damaged, so sharpen or replace it. Another possibility is that the saw chain isn't oiled, so oil the saw chain and drive sprocket.
General| Brand | Mac allister |
|---|---|
| Model | MGS1815-Li |
| Category | Cordless Saw |
| Language | English |
Covers work area, electrical, and personal safety precautions for power tools.
Guidelines for battery tool use, garden saw specific warnings, and kickback prevention.
Information on reducing vibration/noise exposure and understanding safety symbols.
Identifies product components and guides the initial unpacking process.
Instructions for assembling the guide bar, saw chain, and sprocket.
Crucial steps for adjusting saw chain tension for safe operation.
Guidance on charging the battery pack and checking its capacity.
Defines the product's purpose and explains basic controls like the on/off switch.
Details on safe cutting techniques, kickback avoidance, and after-use procedures.
Instructions for routine cleaning and general care of the product.
Specific care and upkeep for the guide bar and saw chain.
Guidance for solving common problems and information on product repair.
Details on customer care, warranty, spare parts, and technical specifications.
Statements and references regarding the product's compliance with regulations.
To Next Page