EN
23
In
more
detail...
MHT60060
by MacAllister
Power cord
If the power cord is damaged, it must be replaced by the manufacturer, its service
agent or similarly qualied persons in order to avoid a safety hazard.
UK plug (only for UK market)
If you need to replace the tted plug, then follow the instructions below.
IMPORTANT: The wires in the mains lead are coloured in accordance with the
following code:
Blue – Neutral
Brown – Live
As the colours of the wire in the mains lead of this product may not correspond
with the coloured marking identifying the terminals in your plug, proceed as
follows. The wire, which is coloured blue, must be connected to the terminal,
which is marked with N or coloured black. The wire, which is coloured brown,
must be connected to the terminal, which is marked L or coloured red.
13 AMP fuse
approved to
BS 1362
Brown L(Live)
Cable grip
Outer sleeve
Connect
Blue to
N(Neutral)
Care and maintenance
1. Keep the cutting device (blade) (13) clean and free of debris. Remove
trimmings with a brush.
2. Apply a small amount of suitable lubricant on the cutting device (blade) to
retain a good cutting performance (Fig. 13).
Cutting device (blade)
WARNING!
Wear safety gloves when working on the cutting device
and close to it! Use appropriate tools to remove debris, e. g. a brush
or wooden stick! Never use your bare hands!
To Next Page
