24 25
MPWP2100-2 By MacAllister MPWP2100-2 By MacAllister
Getting Started . . .
Getting Started . . .
Before you startBefore you start
2.
Remove the cap (21b) from the detergent tank (21a). Then add detergent to the tank
and attach the cap to the tank (Fig. 17).
3. Adjust the detergent spraying mode by the detergent adjustment
(21c) (Fig. 18).
Fig.
17
21b
21a
Fig. 18
21c
WARNING!
Do not attempt to use it on steps or use it vertically on walls. Never attempt to
touch the rotating nozzle while operating (Fig.19)!
Fig. 19
WARNING! Never operate the trigger (16c) of the spray gun (16) during the
adjustment of the extension lance length. Danger of injury!
WARNING! Never place weights or apply forces on the extension lance (13)
this leads to damage the product (Fig. 20)!
Fig. 20
Connection to the water supply
WARNING! Although this product is suitable for attachment to the drinking
water supply local regulations may prohibit the connection to drinking water
connections!
Observe the regulations of your local utility company when connecting the
product to a water supply line! If it is prohibited to connect to the drinking water
EN 12729
type BA. Make sure that the hose is at least a diameter of 12.7 mm (1/2”) and
is reinforced!
If your water supply is potable water, ensure that the pressure washer is
connected to a non-return valve system (type BA).
A Type BA system prevents the contamination of drinking water and must be
connected to the water tap output.
The check valve is sold separately in stores.
GP65-3663602939702-EN-V06.indd 24-25 11/2/16 6:05 PM
To Next Page
Loading...
