Mac allister MPWP2200 - Troubleshooting

EN
34
EN
In more detail...
MPWP2200 by MacAllister
Troubleshooting
Troubleshooting
Suspected malfunctions are often due to causes that the users can x themselves.
Therefore check the product using this section. In most cases the problem can
be solved quickly.
WARNING!
Only perform the steps described within these
instructions! All further inspection, maintenance and repair work
must be performed by an authorised service centre or a similarly
qualied specialist if you cannot solve the problem yourself!
Problem Possible cause Solution
1. Product
does not
start
1.1. Not connected to power
supply
1.2. Power cord or plug is
defective
1.3. Other electrical defect to
the product
1.4. Trigger lock has not been
deactivated
1.5. Nozzle clogged
1.1. Connect to power supply
1.2. Contact your nearest
authorised service centre
1.3. Contact your nearest
authorised service centre
1.4. Unlock the trigger
1.5. Clean the nozzle
2. Product
does not
reach full
power
2.1. Extension cord not
suitable for operation with
this product
2.2. Power source (e.g.
generator) has too low
voltage
2.3. Air vents are blocked
2.4. Water inlet volume is too
low
2.5. High-pressure hose is
leaking
2.6. Seals worn
2.7. Intake lter dirty
2.8. Air being sucked into the
system
2.1. Use a proper extension
cord
2.2. Connect to another power
source
2.3. Clean the air vents
2.4. Increase water inlet
quantity
2.5. Replace high-pressure
hose
2.6. Contact your nearest
authorised service centre
2.7. Clean the lter
2.8. Check tightness of hose
ttings
3. Oil leak 3.1. Seals worn 3.1. Seals worn
MNL_MPWP2200_MAC_GB_V5_200528.indd 34 5/28/20 8:39 AM