Mac allister MPWP2200 - Page 35

EN
35
EN
In more detail...
MPWP2200 by MacAllister
Troubleshooting
Problem Possible cause Solution
4. Strong
pressure
uctuations
4.1. Nozzle clogged
4.2. Water inlet volume is too
low
4.3. High-pressure hose is
leaking
4.4. Seals worn
4.5. Intake lter dirty
4.6. Air being sucked into the
system
4.1. Clean the nozzle
4.2. Increase water inlet
quantity
4.3. Replace high-pressure
hose
4.4. Contact our nearest
authorised service centre
4.5. Clean the lter
4.6. Check thickness of hose
ttings
5. Water
leakage
from
product
5.1. Seals worn 5.1. Contact your nearest
authorised service centre
6. Excessive
vibration/
noise
6.1. Screws and nuts
loosened
6.2. Motor problems
6.3. Water inlet volume is too
low
6.1. Check screws and nuts
for tightness and re-
tighten as necessary
6.2. Contact your nearest
authorised service centre
6.3. Increase water inlet
quantity
7. No
detergent
taken in
7.1. Soap tank not attached
7.2. Detergent too dense
7.3. Deposits or restriction in
detergent circuit
7.1. Attach the soap tank
7.2. Dilute with water
7.3. Flush with clean water
and eliminate any
restrictions. If the problem
persists, contact an
authorised service centre
8. No water
jet
8.1 Trigger is not squeezed
8.2 Trigger lock is activated
8.3 No water supply
8.4 Filter is dirty
8.5 Hose blocked
8.6 Nozzle blocked
8.1 Squeeze the trigger
8.2 Deactivate the trigger lock
8.3 Check water supply
8.4 Clean lter
8.5 Check hose
8.6 Check nozzle
MNL_MPWP2200_MAC_GB_V5_200528.indd 35 5/28/20 8:39 AM