23
MSHP2800D-2
In more detail . . .
General operation
1.
Check the product, and accessories for damage before each use. Do not use the
product if it is damaged or shows wear.
2. Double check that accessories are properly xed.
3.
Push the product forward by its handle. Keep the handle dry and clean to ensure
safe support.
4.
Ensure that the air vents are always unobstructed and clear. Clean them if necessary
with a soft brush. Blocked air vents may lead to overheating and damage the product.
5.
Switch the product off immediately if you are disturbed while working by other people
entering the working area. Always let the product come to complete stop before
averting.
6.
Do not overwork yourself. Take regular breaks to ensure you can concentrate on
the work and have full control over the product.
7. Inspect the material to be shredded before starting. Remove any objects or debris
that could be thrown, jammed or become entangled in the blades. Remove any soil
from root balls. Foreign bodies like stones, glass, metals, fabrics, or plastics must
not enter the feeding funnel, these could damage the blades.
8.
Always place the product on rm, level ground. During operation, do not tilt or move.
9.
Allow the cutting means to reach full speed before feeding the material into the
feeding funnel.
10.
Do not ll soft waste such as kitchen rubbish into the feeding funnel, but compost them.
11.
Long material extending out from the product could lash out when being drawn in
by the blades. Keep at safe distance.
12. Only insert as much material so that the feeding funnel will not be blocked up.
13. Keep to the working speed of the product and do not overload it.
14. Keep a few dry branches for the end, as they will help clean the product.
15. Only switch the product off when all of the shredding material has passed through
the dischargechute. Otherwise, the discharge chute may jam the next time you
switch the product on.
16. Ensure the shredded material can fall freely from the discharge chute.
17. To make ner compost the shredded material can be shredded for a second time.
18.
Do not allow the shredded material to build up to a level where it blocks the discharge
chute. If the material builds up too far it could reach the cutting blades and be thrown
out of the feeding funnel.
19.
Organic material contains a large amount of water and sap that can stick to the
product. To avoid this, the material should be left for a few days to dry out. Large
branches however are best shredded when they are fresh.
Operation
To Next Page
