4
MSHP2800D-2
Safety information
Getting Started . . .
9. Before use check the supply and extension cord for signs
of damage or aging. If the cord becomes damaged during
use, disconnect the cord from the supply immediately. DO
NOT TOUCH THE CORD BEFORE DISCONNECTING THE
SUPPLY. Do not use the machine if the cord is damaged
or worn.
10.
Never operate the machine while people, especially children,
or pets are nearby.
Operation
1. Before starting the machine, make certain that the feeding
chamber is empty.
2.
Keep your face and body away from the feed intake opening.
3.
Do not allow hands or any other part of the body or clothing
inside the feeding chamber, discharge chute, or near any
moving part.
4.
Keep proper balance and footing at all times. Do not
overreach. Never stand at a higher level than the base of
the machine when feeding material into it.
5. Always stand clear of the discharge zone when operating
this machine.
6.
When feeding material into the machine be extremely careful
that pieces of metal, rocks, bottles, cans or other foreign
objects are not included.
7. If the cutting mechanism strikes any foreignobjects or
if the machine should start making any unusual noise
or vibration, immediately shut off the power source and
allow the machine to stop. Disconnect the machine from
the supply and take the following steps before restarting
and operating the machine:
- inspect for damage;
- replace or repair any damaged parts;
- check for and tighten any loose parts.
To Next Page
Loading...
