7
Dear MAC AUDIO Customer,
The Micro X 2000 car hi-fi power amplifier will enable you to satisfy your high demands on sound
reproduction in your car. With its impressive deep-bass power reserves, low harmonic content and neutral
reproduction, the Micro X 2000 takes car hi-fi to new heights. The amplifier is characterized by low
operating current, rapid switching capabilities and excellent temperature stability. Experience and enjoy
how this high-tech machine perfectly reproduces magnificent sound.
Please read all of the owner’s manual before installing and using the amplifier.
1. TECHNICAL DATA
Stereo / Bridged
Max. output power (1 kHz sinus burst 2:8, B+=14.4V) 2 x 250 W / 1 x 500 W on 4 Ohm
Nominal output power (DIN 45 324, B+=14.4V) 2 x 120 W / 1 x 240 W on 4 Ohm
Max. output power (1 kHz sinus burst 2:8, B+=14.4V) 2 x 400 W on 2 Ohm
Nominal output power (DIN 45 324, B+=14.4V) 2 x 200 W on 2 Ohm
Loudspeaker impedance (stereo) 2 – 8 Ohm
Frequency response 5 – 50 000 Hz (-3 dB)
Total harmonic content (DIN 45 403) < 0.05% (1 kHz)
Stereo separation (IEC 581 ) > 60 dB (1 kHz)
Weighted noise distance (IEC A) > 100 dB
Input sensitivity LOW LEVEL INPUT 200 mV – 8 V
Input impedance LOW LEVEL INPUT 50 kOhm
Low-pass filter 30 – 250 Hz, 12 dB per octave
High-pass filter 15 – 250 Hz, 12 dB per octave
Bass boost 0…12 dB at 45 Hz
Supply +12 V (10 – 14.4 V), minus to ground
Fuse 2 x 20 A
Sizes (W x H x D) 263 x 48.5 x 210 mm
Weight 2.95 kg
SUBJECT TO TECHNICAL CHANGE
2. FEATURES
• High-performance audio amplifier with MosFet transistors
• Automatic switching on/off via car radio
• Infinitely adjustable band-pass filter:
- upper limiting frequency (Low-pass) 30 – 250 Hz
- lower limiting frequency (High-pass) 15 – 250 Hz
• Infinitely variable bass equalisation
• Adjustable input sensitivity
• Bridgeable 2-/1-channel mode
• Tri-mode
• Electronic protective circuit against short circuiting, DC offset and excess temperature
• Mute switch for suppressing switch-on crackle interference
• Gilded cinch connections
• Gilded loudspeaker and power-supply screw terminals
• Low-level outputs (cinch jacks) for connecting a subwoofer amplifier
• Operating display (green LED) and overload indicator (red LED)
To Next Page
Loading...
