Need help?Do you have a question about the MAC TOOLS Mentor Touch ET750 and is the answer not in the manual?
General| Brand | MAC TOOLS |
|---|---|
| Model | Mentor Touch ET750 |
| Category | Diagnostic Equipment |
| Language | English |
Explains the structure and meaning of warning notices used in the manual.
Details the workshop operator's duty to ensure safety and compliance with regulations.
Warns about hazardous voltages in vehicle systems and safety measures.
Details risks associated with low and high voltages in vehicles and safety measures.
Covers risks of fatal injury from high voltages in hybrid/electric vehicles and safety measures.
Warns about acid burns from exhaust gas measurement components and safety rules.
Highlights risks of injury from moving vehicle parts and crushing, with safety measures.
Warns about burns from touching hot engine components during testing.
Details risks of fire and explosion from fuel systems and vapors.
Warns about carbon monoxide poisoning from exhaust fumes, especially in pits.
Describes the ET750 as a diagnostic system for workshops using HUB software.
Step-by-step guide to fitting the storage battery into the ET750.
Instructions for connecting the ET750 to the power supply before initial commissioning.
Guides through the initial configuration of the Windows operating system on the ET750.
Instructions on how to start and set up the HUB software for the first time.
Provides information on common faults and troubleshooting steps.
Addresses the "Diagnostic hardware not found" error and its causes/solutions.
Detailed procedure for performing a Windows 10 recovery on the ET750.
To Next Page
