4
PREPARING TO USE THE JUMP STARTER
WARNING! RISK OF CONTACT WITH BATTERY ACID. BATTERY ACID IS A HIGHLY
CORROSIVE SULFURIC ACID.
•
Remove all cord wraps and uncoil the cables prior to using the jump starter.
•
Be sure the area around the battery is well ventilated while the jump starter is being used.
•
Clean the battery terminals before using the jump starter. During cleaning, keep airborne corrosion from coming into contact
with your eyes, nose and mouth. Use baking soda and water to neutralize the battery acid and help minimize airborne
corrosion. Do not touch your eyes, nose or mouth.
•
Determine the voltage of the battery by referring to the vehicle owner’s manual and make sure that the output voltage of the
jump starter is correct.
•
Make sure that the jump starter cable clamps make tight connections.
JUMP STARTER LOCATION
WARNING! RISK OF EXPLOSION AND CONTACT WITH BATTERY ACID.
•
Locate the jump starter as far away from the battery as the DC cables permit.
•
Never place the jump starter directly above the battery being jumped; gases from the battery will corrode and damage the
jump starter.
•
Do not operate the jump starter in a closed-in area or restrict the ventilation in any way.
SPECIFICATIONS
Heavy-duty battery clamps
Fuse
Cord/clamp holder
12V DC power outlet
AC charging socket
Battery status button
Charging/battery status LEDs
SPECIFICATIONS
Model #
Internal
Battery Type
Capacity
Nominal
Voltage
12V Aux DC
Power Output
Rated
Cranking Amps
Fuse
MTPROG
Sealed,
maintenance-free AGM
lead-acid
20Ah (C20) 12V DC 15A 400 300A
Model #
Charger
Input
Charger
Output
Operating
Temperature
Charging
Temperature
Storage
Temperature
Weight
lbs / kg
Dimensions
in / mm
MTPROG
100-240V,
50/60 Hz,
0.7 A max.
12V 2 A
-10°C (14°F)
to 40°C (104°F)
0°C (32°F)
to 40°C (104°F)
-15°C (5°F)
to 40°C (104°F)
23 / 11
16 x 4.72 x 12.6
405 x 120 x 320
To Next Page
Loading...