MAC3 PresSystem Manual

manual utilizare presostat electronic
pressystem
14
i
o
n
 PresSystem poate fi instalat in orice pozitie.
 Inainte de a instala dispozitivul, amorsati
corect pompa.Instalati PresSystem in
apropierea pompei (la pompele de suprafata).
Verificati ca nu exista vibratii daunatoare daca
PresSystem este instalat direct pe pompa.
 Folositi pentru instalatie tevi de dimensiune
egala sau mai mare cea de pe PresSystem.
 Evitati pozitionarea in locuri susceptibile la
formarea condensului.
 Evitati plasarea dispozitivului in locuri unde
temperatura poate scadea sub zero grade
Celsius (0°C).
 Instalati un vas de expansiune pentru a
evita pornirile repetate ale pompei. Folosirea
unui vas de expansiune protejeaza instalatia
de Loviturile de Berbec (suprapresiune), ce pot
defecta instalatia. Vasul de expansiune se va
monta numai dupa PresSystem.
Pentru dimensionarea corecta a vasului de
expansiune se recomanda instalarea unui vas
cu capacitatea de 10% din debitul maxim al
pompei:
EXEMPLU:
Pompa de 100lt/minvas de expansiune de
10lt
Valoarea presiunii de pre-incarcare cu aer a
vasului de expansiune trebuie sa fie aprox.
80% din presiunea instalatiei
Pentru intretinerea usoara a instalatiei
hidraulice:
 PresSystem can be installed in any position.
 Before installing the device, make the perfect
priming pump.
 Install the PresSystem near the pump. Check
that there are no vibrations that can damage
the device when PresSystem is mounted
directly on the pump.
 Use pipes with a diameter not less than the
pipe of PresSystem.
 Avoid places where it is possible
condensation.
 Avoid locations where the temperature can
drop below zero degrees Celsius (0°C).
 Install an expansion tank to avoid continuous
restarts of the pump that could increase the
consumption of electrical energy regardless of
the used device.
The use of the expansion tank avoids
overpressures that could be damaging for the
system
For correct sizing of the expansion tank is
recommended to install an expansion tank
10% of the maximum capacity of the pump:
Example:
Pump 100lt/minexpansion tank 10lt
The value of expansion tank pre-charging must
be about 80% of the system pressure.
For easier maintenance of the hydraulic
system:

MAC3 PresSystem Specifications

General

Brand	MAC3
Model	PresSystem
Category	Lawn and Garden Equipment
Language	English