MAC3 PresSystem - Page 33

manual utilizare presostat electronic
pressystem
33
porneste pompa cand presiunea
este mai mica decat presiunea
minima de repornire. Pompa
este oprita cand presiunea
masurata in instalatie atinge
presiunea maxima setata.
 Lumina intermitenta: modul de
operare poate fi modificat
apasand butoanele + / -
a) Daca se apasa butonul EDIT,
valoarea va fi inregistrata
permanent.
b) Daca se apasa butonul ON/OFF,
valoarea nu este salvata si se
poate iesi din meniu.
PresSystem activates the pump
when the pressure measured is
lower than the restart pressure. The
pump is switched off when the
measured pressure reaches the
maximum pressure.
For details on the function F6 refer
to paragraph: "Pressure switch
Operation ".
 Blinking: the operating mode ON/OFF
can be modified by using the + / -
buttons.
a) If the EDIT button is pressed the
value will be stored permanently
b) If the ON/OFF button is pressed
the value will not be stored and it is
possible to exit without saving.
5
LED PUMP ON:
 Led Activ: pompa functioneaza
 Led Stins: pompa este oprita
 Led Intermitent: pompa functioneaza
dar dispozitivul se va opri pentru a
permite atingerea presiunii necesare.
LED PUMP ON:
 Led ON: the pump is running
 Led OFF: the pump is not running
 Led Blinking: the pump is running but
the device is going to stop for the
achievement of the system pressure
6
LED PRESSURE:
 Led Activ: afiseaza presiunea
masurata a instalatiei. Daca se apasa
butonul EDIT, este afisata presiunea
maxima setata a instalatiei.
 Led Stins: nici o actiune
 Led Intermitent: presiunea afisata
reprezinta presiunea maxima setata si
poate fi modificata cu butoanele + / -.
Daca aceasta valoare este modificata
se vor schimba automat si valorile
presiunii minime si presiuni de intrare
LED PRESSURE:
 Led On: displays the measured
pressure. If the EDIT button is
pressed, the maximum pressure of the
system is displayed.
 Led Off: no action
 Led Blinking: the pressure on the
display represents the maximum
pressure system and can be changed
with the + / - keys.
If the value will be store, it will change
the value of restart pressure and the