MAC3 PresSystem - Page 44

manual utilizare presostat electronic
pressystem
44
03
- Eroare
Control
extern prin
flotor
- Float switch
control
PresSystem este configurat sa
porneasca/opreasca pompa prin
comanda externa de la intrarea
auxiliara J5.
Daca auxiliarul J5 nu este folosit
trebuie facuta o punte (scurt-
circuit) in terminalul J5 (vezi
sectiunea 3.2)
SOLUTII:
 Daca nu folositi un flotor,
verificati ca jumperul sa faca
o punte in terminalul J5
 Daca este folosit un flotor,
verificati ca acesta inchide in
pozitia ce indica prezenta
apei.
The PresSystem is configured to
turn on/off the pump with an
external command on the
auxiliary input J5.
If J5 is not used it is necessary to
short-circuit the terminal J5 (see
section 3.2).
SOLUTIONS:
 If you are not using a float
switch, check for the jumper
in J5
 In case of use of a float
switch, check that it closes in
the position that indicates the
presence of water.
04
- Presiune
prea mica
- Low
pressure
Presiunea masurata de
PresSystem in instalatie la Prima
Utilizare este sub 1 bar.
Ce trebuie facut:
1. Pentru a reporni sistemul si a
iesi din eroare trebuie apasat
butonul ON/OFF pana se
afiseaza “OF”.
2. Apasati din nou butonul
ON/OFF pentru a reporni
dispozitivul.
SOLUTII:
 Verificati sa nu aveti pierderi
mari in instalatie
 Verificati presiunea efectiva
a apei
 Verificati amorsarea corecta
a pompei.
The pressure measured by the
PresSystem during the first
startup is below 1 bar.
ACTIONS:
1. To restart the system and
exit from the error you must
press the ON/OFF button to
display "OF".
2. Press again ON/OFF button
to restart the system.
SOLUZIONI:
 Check that there is no a big
leakage on the system.
 Check for water presence.
 Check for correct pump
priming.
05
(Vers.Cosφ)
-Protectie
SupraAmperaj
- Current
protection
Curentul Absorbit(amperajul) de
la pompa este mult mai mare
decat pragul setat (LED
CURRENT).
Ce trebuie facut:
The current absorbed from the
pump is more high than the
threshold set on PresSystem
(LED CURRENT).
ACTIONS: