DL806 and DL1608 Owner’s Manual
9
If you had been mixing with an iPad mini or iPad Air, but would rather use an iPad 2, iPad (3rd generation)
or iPad (4th generation), the included iPad tray will need to be reinstalled. The iPad tray insert only
needs to be reinstalled if you are mixing with the iPad 2, iPad (3rd generation) or iPad (4th generation).
Here’s how to reinstall the iPad tray:
(1) remove the four screws from the mixer, numbered 1 to 4 in the illustration below.
(2) remove the iPad mini (or iPad Air) tray insert (if applicable).
(3) slide the included standard tray insert into the mixer as displayed below.
(4) put the screws back into the mixer from where you just removed them to hold the tray insert into place.
The iPad tray insert doesn’t need to be locked down If switching regularly between iPads.
Instead, hand-tighten the screws to the mixer before sliding the tray insert back in.
This way
they can’t get lost and you’re still able to slide the tray insert in and out as needed.
1
2
3
4
1
2
3
4
Tray Insert
Tray
To Next Page
Loading...
Need help?
General
