Madison Park Signature MPS153-0086 User Manual

Page 1 of 2
ASSEMBLY INSTRUCTIONS
Holloway Table Lamp (Item#: MPS153-0086)
Important Safety Instructions:
• For safety purpose, this lamp is equipped with a polarized plug (one blade is wider than the other). If the plug does
not fit securely into your outlet, do not force it, contact a professional electrician. Never alter the plug in any way.
• These instructions are provided for your safety. It is very important that they are read carefully and completely
before assembling fixture.
• This fixture has been rated for up to (1) 9.5-watt LED maximum TYPE A bulb (included).To avoid the risk of fire,
do not exceed the recommended wattage.
Pre-assembly:
 Do not discard any contents until after assembly is complete to avoid accidentally discarding small parts or
hardware.
 Remove all parts and hardware from box along with any plastic protective packaging.
Parts Enclosed:
Warning:
 Wires and cables are all attached (further wiring is not needed from consumer). When unpacking product, be
careful to not pull wires as it may result as a bad connection. Do not plug into electrical outlet until lamp is fully
assembled.
Note:
Turn the power off (unplug from the wall outlet) before replacing the bulb. Make sure the bulb has sufficient time to cool
down.

Madison Park Signature MPS153-0086 Specifications

General

Brand	Madison Park Signature
Model	MPS153-0086
Category	Outdoor Light
Language	English

Summary

Important Safety Instructions

Polarized Plug Safety

Lamp has a polarized plug; do not force into outlets or alter it. Contact an electrician if it doesn't fit.

Read Instructions Carefully

Instructions are for your safety and must be read carefully and completely before assembly.

Wattage Limit

Fixture rated for 9.5-watt LED bulb. Do not exceed wattage to avoid fire risk.

Pre-Assembly Preparation

Keep Contents Intact

Do not discard any contents until assembly is complete to avoid losing small parts or hardware.

Unpack All Parts

Remove all parts and hardware from the box, including any protective packaging.

Parts List

Enclosed Components

Details the items included in the package: screws, metal dish, clips, glass shade, socket, tube, and base.

Assembly Instructions

Step 1-2: Setup

Unpack parts, place lamp base on a flat surface.

Step 3-4: Tube and Socket

Screw tube onto base, then screw socket assembly onto tube carefully avoiding cord twist.

Step 5-6: Bulb and Shade

Screw in the light bulb, attach glass shade using clips and screws with metal dish.

Step 7: Completion

Final confirmation that assembly is completed.

Care and Maintenance

Cleaning Instructions

Wipe with a soft dry cloth only and avoid harsh chemicals or abrasives.