8
and detergents and dry them thoroughly. Wipe the outside of the
mixer case with soft wet cloth, then rub it dry.
- Assure yourself that the switch of operating regimes (4/ Picture1)
is in position «0» - OFF.
- Choose proper accessories for your products.
- Insert the shank end of each accessory in the hole provided in the
mixer case. Slightly pressing x the accessories in the holes until it
clicks.
- Be sure that the accessory for mixing dough marked with a ring is
inserted in the left hole (if you see on the site with holes).
- Place the container with the products on a solid stable surface of
the table. Holding the mixer by the handle plunge the work surfaces
of the accessories in the container with product.
- Connect the electric cable plug to the mains.
- Switch on the mixer and choose the required speed with switch (4/
Picture1).
ATTENTION! Avoid the contact of the liquid being mixed with the
mixer case.
- After the ingredients reach the required consistency move the
switch to position «0» OFF.
Before removing the accessories make sure that movable parts are
completely stopped and disconnect the switch from the mains.
Press button (5/ Picture1) to remove the accessories.
Be careful to remove the accessories when the switch is in position
«0»-OFF.
After terminating the use put the switch to position «0» - OFF.
Cleaning and maintenance
To Next Page
Loading...