Maestro MR755 - Page 5

5
Instructions for use
Tips
- If the product picture is inconsistent with the actual product, the actua product shall
prevail.
- Before using for the rst time, please take out the fryer and the fryer to clean with
detergent. After cleaning, put it into the electric oven and preheat for 10 minutes to
eliminate the residual odor during packaging or transportation.
- A small amount of smoke or slight odor may be emitted when you start using it, which is
normal.
- Please use the original accessories of this product.
- The light inside the machine is caused by the heating of the heating tube. When the
machine reaches the set temperature, the heating tube stops heating and the light
temporarily disappears. When the temperature is lower than the set temperature, the
heating tube will work again and the light will resume, which is a normal phenomenon.
- Do not use plastic or paper containers that are not heat-resistant to carry food into the
electric oven;
- Do not use glass or ceramic plates or lids;
- The fryer is not a water-holding part. When the water level of the fryer is too high, it will
cause water leakage. This is a normal phenomenon. It is recommended to place the fryer
in a sink for cleaning instead of putting water in the machine;
- The temperature of the outer surface and the air outlet may be very high when the
machine is in working condition and after the work is nished for a period of time. Please
do not touch or move it to avoid danger.
- The product should be stably placed on a at table, so that the power cord has a su󰀩cient
length to plug into the socket with a ground wire (see the gure below), and keep the air
around the product ventilated and not close to ammable materials.
- Before placing the ingredients, preheat the machine for 3-5 minutes, the cooking e󰀨ect
will be better.
- If you nd that the product is malfunctioning, please stop using it and contact the
company’s service department immediately.
- Please keep the manual for future reference during use.
Instructions
First time using
1. Remove all packaging materials.
2. Thoroughly clean the frypot and pan with hot water, detergent and non-abrasive sponge.
3. Wipe the inside and outside of the product with a damp cloth. This electric oven is
heated by hot air. Never pour oil or grease in the fryer.
Preparation for use
1. Place the product on a stable, level and at surface. Do not place the product on a
surface that is not heat resistant.
2. Place the frypan in the frypot correctly. Never pour oil or other liquids into the fryer.
3. Do not place objects on top of the product, as this will block the airow and a󰀨ect the
EN