11
minutes 00:00. Press the button “Delayed Start” to set the desired delay time.
4) Press the button “Start” to conrm. Two indicators will ash on the display, the delay time
starts counting down, when the selected program of cooking will start.
The function of “Heating”
At the end of the run, all programs (with the exception of “Yogurt”) automatically go into
heating mode. The temperature is 70 ° C.
To switch o the heating, press the “Cancel / Heat” button.
Also in the multicooker it is possible to perform the heating of the cooled products. To do
this, put the products into the bowl. When the multicooker is in the standby mode, press
the button “Cancel / Heating”. The products will start warming up.
The action facility canceling
Any action or program can be canceled by pressing the button “Cancel / Heating”, the
multicooker will enter into standby mode.
After use, switch o the multicooker by pressing the button, and then wean it o from
electrical power network
Cleaning and maintenance
ATTENTION!
- Never clean the device while it is connected to the mains.
- Do not use abrasive and aggressive detergents, solvents, alkaline, metal objects and
wash-ups.
- Never submerge electric drive, its mains cable and plug in water or other liquid, do not
wash the drive in water or in a dish washing machine.
Cleaning of multicooker’s parts
- Wipe the housing rst with a slight wet then with soft dry cloth. Let it dry completely.
The bowl of the multicooker must be cleaned after each use. You can use a dishwashing
liquid and a soft cloth. Do not use abrasive cleaners! You can not use force to clean the
bowl. In case of severe contamination ll it with water and leave for a while, then gently
wash it.
The steam valve and water trap must be removed and cleaned after each use. For
cleaning, remove the valve from the multicooker’s lid. Rinse the valve parts and the water
collector with running water, wipe dry and dry before installation.
Accessories (a spoon, a ladle, a container - a steamer, a yogurt and a measuring glass)
are washed in warm water, rinsed and wiped dry.
Note: After a certain period of time with frequent use of the appliance, the color of the non-
stick coating of the bowl may change due to steam, humidity of food, acids and a mixture
of ingredients. These changes are not a defect and do not aect the operation of the
product.
EN
To Next Page
Loading...
