9
6 Jam 4 h 30 min 22 Noodels 35 min
7 Bake 50 min 23 Milk Porridge 40 min
8 Pasta
Stage 1 before
boiling
water, 2 stage 8
min
after laying the
spaghetti
24 Soup 1 h
9 Stew 45 min 25 Вuckwheat 1 h
10 Reheat 25 min 26 Vegetable 30 min
11 Rice
No installed,
about 1 h
27 Oatmeal 20 min
12 Pizza 35 min 28 Вean 1 h
13 Warm Milk 10 min 29 Fried Rice 30 min
14 Porridge 1 h 30 Custom 10 min
15 Yogurt 8 h
16 Meat 50 min
Standard operations, program selection
Before starting any one of the programs, inspect the multicooker and the bowl.
Make sure that the bottom of the bowl and the surface of the heating element in the
multicooker camera are clean, without undesired objects.
Put the products into the bowl.
Set the bowl into the multicooker camera, slightly rotate it counterclockwise to ensure a
tight touch of the bottom of the bowl and the heating element.
Close the lid until the latch snaps into place.
Connect the multicooker to an electrical outlet. The display will show “P -: -”
- Select the program. The multicooker has 30 basic programs installed. For selecting and
running the required program, please take the following steps:
1) Press the “Menu” button (6/ Picture 2) until the indicator light of the needed program is
highlighted. The cooking time of this program will be indicated on the display and applied
by default.
2) Press the button “Start” to conrm and start the selected program (2/ Picture 2). On the
display will start the time count backwards; the multicooker will carry out a programme.
3) At the end of the selected program will sound the signal and the multicooker will
automatically pass to mode “Heating” (Heating mode is not available for the Yogurt
program). This will be indicated by the bb indicator on the display.
EN
To Next Page
Loading...
