Maestro MR795 - Preparation for Work; Using Parts and Accessories; Bowl Usage and Care

6
Preparation for work
- Remove all wrap materials and stickers
- Make sure that all the parts of appliance don’t have damages.
- Check the assembly of the multicooker.
- Inspect all parts of the multicooker, power cord and plug. Ensure in lack of any damages
incurred in the transportation, such as:
•damages of the frame or lid, dents or cracks;
• damages of the non-stick coating of the bowl;
• damages of power cord and plug.
ATTENTION! If any of the above mentioned damages are present, do not install the
multicooker and immediately provide the information about damages to your Seller.
- Wipe the frame of the appliance with a damp cloth. Wash the bowl, container, spoon and
ladle in warm soapy water, rinse and wipe dry.
In choosing a place for installing a multicooker, it must be not exposed to direct sunlight,
near heated appliances, or in a draft. All this can a󰀨ect to the temperature inside the
multicooker and reduce the quality of the prepared dishes.
-Install the multicooker on a at, non-slip surface, giving the free space on all sides, at least
20 cm, for su󰀩cient air circulation.
For surfaces that can be damaged by heat, it is recommended to use heat-insulating, non-
ammable supports.
- Before plugging the multicooker in, make sure that the power parameters, indicated in
the table of technical characteristics, coincide with power supply of your network. The high
voltage using may cause the damage of the appliance and even make the re. The low
voltage using leads to unsatised quality cooking.
Attention!
At the time of the rst switching on the device, a specic smell or smoke may appear for a
short time. These are normal phenomena due to the presence of preservation materials on
the electric drive motor. They shall disappear after several minutes of the device operation.
Rules of using of multiccoker’s parts and accessories
Rules of bowl using
The inner bowl with non-stick coating is designed for this model of the multicooker and
should not be used with any other appliance. Please, make sure that the bowl is rmly in
contact with the heating plate by turning it slightly in a counterclockwise direction.
Wash the bowl after each use. In bowl cleaning, please do not use alkaline solutions,
caustic or abrasive cleaners, or hard, sharp objects, in order to prevent the damage of
coating; no excessive force in bowl cleaning.
To prevent burns, remove the bowl from the appliance by wearing on kitchen gloves or
allow the bowl to cool before removing it from the appliance. Do not wash it immediately