Need help?Do you have a question about the MAG FORGE M100R and is the answer not in the manual?
General| Model | MAG FORGE M100R |
|---|---|
| Type | Mid Tower |
| Color | Black |
| Case Form Factor | ATX |
| Motherboard Support | ATX, Micro-ATX, Mini-ITX |
| Side Panel | Tempered Glass |
| Pre-installed Fans | 3 x 120mm ARGB fans |
| Expansion Slots | 7 |
| CPU Cooler Clearance | Up to 160 mm |
| Material | Tempered Glass |
| Cooling Support | Front: 3 x 120 mm / 2 x 140 mm |
| Radiator Support | Rear: 120 mm |
| Drive Bays | 2 x 3.5", 2 x 2.5" |
| PSU Support | ATX |
Details on PC case size, fan controller, materials, and dust filters.
Information on fan support configurations and the number of drive bays.
Details on expansion slot count and the front panel I/O ports.
Specifications for radiator compatibility and component clearances.
Overall case dimensions and supported motherboard form factors.
Identifies and describes the functions of each port on the front I/O panel.
Explains how to control LED effects using the dedicated LED switch button.
Guide for installing Solid State Drives (SSDs) and Hard Disk Drives (HDDs).
Instructions for removing the left and right side covers for the M100R model.
Instructions for removing the left and right side covers for the M100A model.
Step-by-step guide for installing the motherboard into the PC case.
Procedure for installing a graphics card into the expansion slots.
Instructions for installing the Power Supply Unit (PSU).
Details on control board dimensions, connectors, and ARGB pin definitions.
Lists and describes the various LED lighting effects controllable via the board.
Diagram illustrating how to connect ARGB fans to the control board.
Important note regarding the maximum number of LEDs supported and potential issues.
To Next Page