EasyManua.ls Logo

Magic Bullet mini - Using the magic bullet Mini; storing leftovers in the magic bullet Mini Cups

Magic Bullet mini
11 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
1312
Using the
magic bullet Mini
®
.
3 Twist on the Cross Blade
until the blade and Cup
are tightly sealed.
2 Load the ingredients into
the Cup (do not exceed
the MAX line).
4 Line up the tabs on the
Cup and with the tabs on
the Motor Base. Press the
Cup down onto the base
to turn on the machine.
Here’s how it works:
The magic bullet Mini
®
will
blend for as long as you
press the Cup down onto
the Motor Base. To stop
blending, simply release
pressure on the Cup.
Using the magic bullet Mini
®
is as easy as 1, 2, 3:
caution:
Before using the Cross Blade,
check the gasket to make sure it is
not damaged and it is completely
seated in the Cross Blade Unit
before each use.
Never put your hands or utensils
near the moving Cross blade and
never use your hands or utensils to
press the activator buttons down
while the Motor ase is plugged in.
If the Cross Blade stops spinning
while in lock on mode, immediately
unplug the magic bullet Mini
®
.
Hard ingredients like carrots or
celery can get stuck in the Cross
Blade and stop it from turning. If
this happens, unplug the magic
bullet Mini
®
right away. Remove
the blade/cup assembly from the
Motor Base, and give ingredients
a good shake to unblock the Cross
Blade. If the Cross Blade still
remains obstructed, twist the Cross
Blade attachment off of the Cup
and carefully spin the metal blades
using a utensil (not your fingers) to
release the blockage. Reattach the
Cross Blade to the Cup, plug in the
magic bullet Mini
®
and try again.
It should spin normally.
Never run the magic bullet Mini
®
for more than one minute at a
time, as it can cause permanent
damage to the motor. If the motor
stops working, unplug the Motor
Base and let it cool for a few hours
before attempting to use it again.
Your magic bullet Mini
®
has an
internal thermal breaker that shuts
the unit off when it overheats.
Letting the thermal breaker cool
down should allow it to reset.
1 Before first use, review all warning and caution statements in
the Important Safeguards section (pages 2–6). Clean Blending
Cups and Cross Blade with hot, soapy water before use.
storing leftovers in the
magic bullet Mini
®
Cups:
The magic bullet Mini
®
includes a
Stay Fresh Resealable Lid that
twists directly onto your magic
bullet Mini
®
Cups, allowing you
to prep food ahead of time, keep
leftovers fresh, or take your meal
on the go without dirtying an
extra storage container.
“Lock-on” mode:
For hands-free operation,
press down and gently turn the
Cup clockwise until the tabs
lock under the lip of the Motor
Base. Once you are in lock-on
mode, the motor will run
continually (do not run for
longer than a minute!). To stop
blending, simply twist the Cup
counter-clockwise to release.

Related product manuals