How to fix a Magic Care PULSATRONIC TMB-1112 Blood Pressure Monitor with no power?
If your Magic Care Blood Pressure Monitor isn't turning on, there are a few potential causes. First, the batteries might be dead, so try replacing them with new ones. Second, the batteries may not be inserted correctly; ensure they are properly aligned. Finally, if you're using the AC adapter, make sure it's fully and correctly inserted.
What to do if Magic Care PULSATRONIC TMB-1112 Blood Pressure Monitor shows E10, E11 or E20?
If your Magic Care Blood Pressure Monitor displays error codes E10, E11, or E20, it could be due to a few reasons. It's possible the monitor detected movement or talking during the measurement, or the pulse was too weak. In this case, relax for a moment, and then measure again. Another possibility is that the device isn't detecting a pulse signal. Try loosening any clothing on your arm and measure again.
Why is the display dim on my Magic Care PULSATRONIC TMB-1112 Blood Pressure Monitor?
If the display on your Magic Care Blood Pressure Monitor is dim, it probably means the batteries are running low. Try replacing them with a fresh set.
General| Measurement Method | Oscillometric |
|---|---|
| Cuff Size | 22-32 cm |
| Memory | 60 measurements |
| Display | LCD |
| Automatic Shut-off | Yes |
To Next Page
