14
3. Connect the flexible cable conduit from the cooktop to the junction box using a UL listed or CSA approved
conduit connector.
4. Tighten screws on conduit connector if present.
5. Connect the two black wires together using the UL listed wire connectors.
6. Connect the two red wires together using the UL listed wire connectors.
7. Connect the green or bare cooktop cable wires to the white (neutral) wire in the junction box using the UL
listed wire connectors.
8. Install junction box cover.
9. Reconnect power.
Complete Installation
1. Check that all parts are now installed. If there is an extra part, go back through the steps to see which step
was skipped.
2. Check that you have all your tools.
3. Dispose of/recycle all packaging materials.
4. Use a mild solution of liquid household cleaner and warm water to clean cooktop before use. Dry
thoroughly with a soft cloth. (For more information, refer to “Care and Maintenance” section on page 19.)
5. Read the “Operation Instruction” section on page 17.
6. Reconnect power.
NOTE: If the cooktop does not work after turning on the power, check that a circuit breaker has not tripped or
a household fuse has not blown. (Refer to “Troubleshooting” section on page 20.)
To Next Page
Loading...
Need help?
General
