Magicar FAI-440 - Program Feature Setup; Table of the Programming Features; Arm Mode; Silent Arm;Disarm

PRESS BUTTON 4 ONCE PANIC PANIC
PRESS BUTTON 1+2 SILENT DISARM SILENT ARM ANTI-HIJACKING
PRESS BUTTON 3 then 1 CHANNEL 3 CHANNEL 3 CHANNEL 3
3.
2 Program Feature Setup
Under the disarm mode, switch the ignition on and off. Within 10 seconds, press the valet switch 3 times, 2 seconds later, the siren
will chirp for 2 seconds and the system will enter into the program feature mode. Then within another 10 seconds, press the valet
switch to select a defaulted item. After selecting the defaulted item, 2 seconds later, the siren will chirp one (default disable) or two
(default enable) times to indicate the default is changed. For example, if need to change the default of No.3 Dome Light Delay as
enable, after the system enters in the system enters in the program feature mode, within 10 seconds press the valet switch 3 times and
the siren will chirp 3 times. 2 seconds later, the siren will chirp twice to indicate Dome Light Delay is defaulted as enable. Then if also
need to change Default #6 Channel 3 output as enable, press the valet switch 6 times within another 10 seconds and the siren will
chirp 6 times. 2 seconds later, the siren will chirp twice to indicate the Channel 3 output is defaulted as enable. The system will quit
the program feature mode if the door is closed, switch the ignition on and exceed 10 seconds interval between each action. The siren
will chirp 2 seconds to indicate that the system quits the program feature mode.
Table of the Programming Features
No
. CHIRP FUNCTION
CHIRP ONCE
FACTORY DEFAULT
CHIRP TWICE
1 1 CHIRP IGNITION DOOR LOCK/UNLOCK DISABLE ENABLE
2 2 CHIRP DOOR LOCK/UNLOCK TIME 1 SEC. 4 SEC.
3 3 CHIRP DOMELIGHT DELAY DISABLE ENABLE
4 4 CHIRP ACTIVE/PASSIVE ACTIVE PASSIVE
5 5 CHIRP ALARM TIME 30 SEC. 60 SEC.
6 6 CHIRP CHANNEL 3 OUTPUT DISABLE ENABLE
7 7 CHIRP ANTI HIJACKING DISABLE ENABLE
8 8 CHIRP ANTI HIJACKING MODE MODE 1 MODE 2
3.3 ARM MODE:
Under the disarm mode, press button (1) when the ignition is off, the siren will chirp once, lights flash once and lock (depending on
the default as 1 or 4 seconds), the LED flashes slowly, the start kill is on, and then the system enters into the arm mode.
3.4 Silent Arm/Disarm
a. Press button (1) and (2) once simultaneously, the system will enter into the silent arm/disarm. The siren will not sound. If
d
oors, hood or truck are not closed properly, lights will flash three times and LED will flash the memory to indicate that door
s,
h
ood or truck are not closed properly. The triggers of the above three sensors will be bypassed until they are closed properly.
b. If triggered, when the system is silent disarmed, the start kill will be off, lights flash three times, the siren will chirp four tim
es
an
d the LED flashes trigger status. Then the system will enter into the auto rearm mode
.
3.
5 Shock Sensor Bypass
After pressing button (1) to arm, then press button (1) again within 3 seconds, the siren will chirp once and the shock sensor will
be bypassed.
3.6 DISARM MODE:
A. DISARM CODE:
a.
Under the arm mode, press button (2) once, the siren will chirp twice, lights flash twice and unlock. The start kill is off and the
LED flashes rapidly, then the system enters into the auto rearm mod
e.
b.
Under the arm mode, press button (2) once, the siren will chirp 4 times if there was a trigger before. Lights will flash three ti
mes
an
d unlock, the start kill is off, LED flash trigger memories and then the system enter into the auto rearm mode
.
B. T
rigger Memory:
www.shieldtechsecurity.com