Magnetic NF 2 plus - Replacing the Mixed Bed Resin

magnetic
...einfach besser
7
Replacing the mixed bed resin: NF 2 plus, 6 plus
1. Close the ball valves, screw off
the tank
2. Dispose of used resin
with domestic waste, rell
with new resin
3. Screw on the tank, re-
set measuring computer,
see instructions for use
Replacing the mixed bed resin: NF 12 plus, 25 plus
«0»
«0»
1. Close all valves, remove safety strainer on the
drain tap
2. Connect a hose to the drain tap, with the other
hose end in the supplied water permeable collec-
tion bag
3. Connect the inlet to a drinking water tap with
a hose
4. Open the inlet tap and the drain tap and ush
out the resin until clear water comes out - the resin
is then completly emptied.
5. Close the inlet tap and open the vent tap
on the lid. Air can now get into the device and
water in the lling station can ow out of the
drain tap.
6. Used mixed bed resin can be disposed of
with the normal household waste.
7. Close the drain tap, remove the hose and
reinstall the safety strainer.
8. Rell with new resin.
9. Then vent the device again.
10. Put on the lid, connect the hoses and reset the
measuring computer.