Need help?Do you have a question about the Magni Gyro M-24 and is the answer not in the manual?
General| Brand | Magni Gyro |
|---|---|
| Model | M-24 |
| Category | Toy |
| Language | English |
Provides a detailed breakdown of maintenance tasks and intervals for continued airworthiness.
Lists any attached documents or supplements to the maintenance schedule.
Lists relevant maintenance manuals and documentation for airframe and engine.
Defines the owner/operator's responsibility for ensuring maintenance is completed as prescribed.
Outlines the duties and judgment required of personnel certifying aircraft maintenance.
Specifies the recommended standards and practices for performing inspections.
Addresses component retirement and scrap lives as defined by authorities and this report.
Mandates compliance with all applicable Airworthiness Directives and Mandatory Permit Directives.
Details recommended overhaul, additional inspections, and test periods, subject to authority variations.
Covers in-service data and assessments for maintaining airworthiness.
Requires recording of approved changes to the aircraft, engine, or components in logbooks.
Specifies mandatory duplicate inspections for critical tasks or system disturbances.
Describes the requirement for issuing and certifying worksheets for scheduled maintenance checks.
Provides definitions for terms and abbreviations used throughout the maintenance schedule.
Details mandatory compliance with rules and the process for certifying aircraft fitness for flight.
Lists specific maintenance tasks that pilots are permitted to perform.
Outlines the different maintenance check titles, their content, periods, and certification requirements.
Details allowable variations in flying hours and calendar time for maintenance tasks.
Procedure for the daily pre-flight check, covering various aircraft systems and components.
Details the information required for maintenance worksheets, including aircraft and check type.
Covers essential final checks performed after maintenance, including ground runs, certification, and schedule reviews.
Specific maintenance tasks for the 25-hour check, covering flying controls and engine.
Details the extensive inspection and maintenance tasks for the 100-hour service interval.
Structural and zonal inspections as part of the 100-hour maintenance.
Inspection and maintenance of the landing gear at 100-hour intervals.
Maintenance tasks for the flying controls at 100-hour intervals.
Checks on fluid, air, and gas systems as part of the 100-hour maintenance.
Inspection of equipment and environmental factors at 100-hour intervals.
Engine checks and maintenance tasks at 100-hour intervals.
Inspection and maintenance of the rotor system at 100-hour intervals.
Lubrication procedures for the gyroplane at 100-hour intervals.
Checks on the powerplant installation at 100-hour intervals.
Inspection and maintenance of the air induction system at 100-hour intervals.
Checks on the exhaust system security and condition at 100-hour intervals.
Maintenance and checks of the fuel system at 100-hour intervals.
Inspection and maintenance of the electrical system at 100-hour intervals.
Checks and maintenance of the instrument systems at 100-hour intervals.
Inspection of the ignition system components at 100-hour intervals.
Specific maintenance tasks for the 2-year check.
Specific checks for instrument systems required every 2 years.
Maintenance tasks for the 300-hour or 3-year check.
Maintenance tasks for flying controls at 300-hour or 3-year intervals.
Specific maintenance tasks for the 500-hour check.
Maintenance tasks for flying controls at 500-hour intervals.
Inspection and overhaul of the rotor system at 500-hour intervals.
Specific maintenance tasks for the 1000-hour check.
Checks on the powerplant installation at 1000-hour intervals.
To Next Page