INSTALLATION GUIDE
E-SERIES
120VAC / 24VDC
Magnitude, Inc.
Page 1 of 2
14711 Bentley Circle. Tustin, CA 92780 www.MagnitudeInc.com technical@MagnitudeInc.com DOC-GU-400048 Rev. 1
General
This driver is to be installed in accordance with Article 450 of the
National Electric Code. The driver must be installed in a well-ventilated
area free from explosive gases and vapors. Proper operation requires
for free flow of air. This driver should only be installed by a qualied
electrician.
Precautions Before Installing
Check the label and ensure the driver has the proper input voltage and
wattage for the job. Check the wire markings to ensure they match the
wiring diagram on this installation guide.
Quick Specs
Input Voltage 120V AC
Output Voltage 24V DC
Max. Ambient Temp.
-200 C to 700 C (-4°F - 158°F)
Enclosure Nema 3R - Outdoor Use
Min. Installation Space
Between Drivers
5” Inch
Mounting
Select a suitable location capable of supporting the weight of the
driver. Use the two key holes in the wire housing and third hold on the
flange when mounting. It is recommended that the driver be mounted
vertically with the wiring compartment pointing down. Recommended
spacing between drivers is 5”.
5” Min.
Spacing
Wiring
Compartment
Input Connections / Grounding
Remove wire compartment cover plate.
1
Remove knockouts and install wire strain reliefs.
E-SERIES LISTED
FOR MODELS
E20L24DC, E40L24DC, E60L24DC, E75L24DC, E96L24DC
Mounting
Holes
To Next Page
Need help?
General