MAGNITUDE LIGHTING LINDRIVE Series - User Manual

INSTALLATION GUIDE
LINDRIVE SERIES
120-130VAC / 12VDC
Magnitude, Inc.
Page 1 of 2
14711 Bentley Circle. Tustin, CA 92780 www.MagnitudeInc.com technical@MagnitudeInc.com DOC-GU-XXX Rev. 1
General
This driver is to be installed in accordance with Article 450 of the
National Electric Code. The driver must be installed in a well-ventilated
area free from explosive gases and vapors. Proper operation requires
for free flow of air. This driver should only be installed by a qualied
electrician.
Precautions Before Installing
Check the label and ensure the driver has the proper input voltage and
wattage for the job. Check the wire markings to ensure they match the
wiring diagram on this installation guide.
Quick Specs
Input Voltage 100-130V AC
Output Voltage 12V DC
Max. Ambient Temp.
-250 C to 450 C (-13°F - 113°F)
Enclosure IP21 Dry and Damp
Min. Installation Space
Between Drivers
5” Inch
FOR MODELS
SLT20L12, SLT40L12
Mounting
Select a suitable location capable of supporting the weight of the
driver. Use the two key holes in the wire housing and third hold on the
flange when mounting. It is recommended that the driver be mounted
vertically with the wiring compartment pointing down. Recommended
spacing between drivers is 5”.
5” Min.
Spacing
Half hole
mounting flanges

Summary

General Information and Safety

General Installation Notes

Installation guidelines according to National Electric Code and ventilation needs.

Installation Precautions

Verify input voltage, wattage, and wire markings match the installation guide.

Product Specifications and Mounting

Quick Specifications

Key specifications including input/output voltage, temperature, and enclosure rating.

Mounting Instructions

Guidance on selecting a location and vertically mounting the driver using key holes and flanges.

Recommended Spacing

Recommended spacing between drivers is 5 inches for proper airflow and operation.

Wiring and Dimming

Input Connections

Instructions for routing input wires to the driver after removing the input wiring cover.

Output Connections

Instructions for routing output wires to the driver after removing the output wiring cover.

Dimming Compatibility

Compatibility with MLV/Incandescent TRIAC dimmers and requirements for smooth dimming.

MAGNITUDE LIGHTING LINDRIVE Series Specifications