2 - How to Set Up the MagTek SCRA Libraries
Dynamag, DynaMAX, and eDynamo| Secure Card Reader Authenticator | Programmer’s Reference (WCF)
Page 9
2 How to Set Up the MagTek SCRA Libraries
2.1 How to Setup Up the MagTek SCRA Development Environment
To set up the MTSCRA Libraries, follow these steps:
1) Download the Dynamag, DynaMAX, and eDynamo Secure Card Reader Authenticator Windows
API Install, available from MagTek.com
(Support > Software > Programming Tools > Dynamag, DynaMAX, and eDynamo Secure Card
Reader Authenticator Windows API>
Dynamag, DynaMAX, and eDynamo SCRA Windows API)
2) Right-click 99510133.exe and select Run as administrator . The installer will place all
dependencies in appropriate paths.
To build and run the MTSCRA Demo software, follow these steps:
1) For 64-bit machine, launch Visual Studio 2013 and open C:\Program Files (x86)\MagTek\SCRA
Windows SDK\Sample Code\CPP\Source\VCDemo.vcxproj
2) For 32-bit machine, launch Visual Studio 2013 and open C:\Program Files\MagTek\SCRA
Windows SDK\Sample Code\CPP\Source\VCDemo.vcxproj
3) In the Solution Explorer , select VCDemo.
4) Select Build > Build VCDemo, or press Shift-F6 to build the MTSCRA Demo.
5) Select Debug->Start Without Debugging to run the MTSCRA Demo, or select Debug->Start
Debugging to run the MTSCRA Demo in debug mode.
2.2 How to Connect MTSCRA WCF Service to WCF Host Demo
To use the WCF Host Demo (MTSCRAWCFHost.exe) use base address http://localhost:8090/MTSCRA
and add two endpoints on it.
<endpoint address="ajax" binding="webHttpBinding" behaviorConfiguration="ajaxBehavior"
contract="MTSCRAWCF.IMTSCRA" />
<endpoint address="mex" binding="mexHttpBinding" contract="IMetadataExchange" />
2.2.1 Connect web service in C# Project
1) Open your C# project
2) Select PROJECT->Add Service Reference
To Next Page
Loading...
