What to do if the red fault indicator light and blue UP/DOWN buttons are permanently lit on MAHA Lifting Systems?
If the red fault indicator light and blue UP/DOWN buttons are permanently lit, this indicates an internal fault. Turn off the main switch and switch it on again after approximately 5 seconds. If the fault reoccurs, notify the service team.
What to do if the MAHA Lifting Systems lift stops when rising and the blue UP button light goes out?
The lift may have reached its upper end position (maximum lifting height), meaning it can only be lowered. Alternatively, if a signal sounds when the UP button is pressed again, it could be due to: a) Heavy load (maximum load exceeded): Lower the lift by pressing the DOWN button and reduce the load. b) Ceiling impact protection triggered: Lower the lift by pressing the DOWN button.
What to do if the MAHA Lifting Systems lift stops when lowering and the blue DOWN button light goes out?
The lift may have reached its end position and can only move upwards. If necessary, the lower end position can be adjusted to ground conditions by the service team. If a signal sounds when the DOWN button is pressed again, the lift has met an obstacle. Free the lift by pressing the UP button and remove the obstacle.
What does it mean if the DOWN button, UP button, and red fault indicator flash more than 10 times on MAHA Lifting Systems?
If the DOWN button, UP button, and red fault indicator flash more than 10 times, this indicates that the system is in configuration mode. Notify the service team.
What to do if support arms hit the ground during lowering of MAHA Lifting Systems?
If the support arms hit the ground during lowering, the lower end position has not been set correctly. Notify the service team.
Why does MAHA Lifting Systems make a signal sound immediately upon switching on?
The signal sound immediately upon switching on may be because a button was pressed by mistake. Release the button. Alternatively, the control panel may have a short circuit, in which case you should notify the service team.
What does it mean if the red fault indicator light flashes continuously on MAHA Lifting Systems?
If the red fault indicator light flashes continuously, it indicates that the permissible control deviation has been exceeded. Notify the service team. It could also indicate a sensor malfunction.
Explanation of hazard symbols and signal words used in the manual.
Procedures to follow in case of equipment malfunction.
Steps to take and information to provide in case of an accident.
Qualifications and responsibilities for personnel operating and servicing the lift.
Specifies the authorized applications and limitations for the lift.
Specifications for the MA STAR 3.5 A model, including load, power, and dimensions.
Specifications for the MA STAR 3.5 S model, including load, power, and dimensions.
Instructions for safely loading, unloading, and moving the packaged lift.
Procedures for raising and lowering the vehicle.
Procedure for safely lowering the vehicle and the function of the CE stop.
Essential safety guidelines for performing inspection and maintenance tasks.
Safety precautions to observe before and during troubleshooting.
Table detailing error displays, their diagnostics, and recommended remedies.
General| Brand | MAHA |
|---|---|
| Model | MA STAR 3.5 A |
| Category | Lifting Systems |
| Language | English |
To Next Page
