Adjust the seat as needed and sit up straight and well back in the seat. To fasten
your seat belt, pull the webbing out of the retractor and insert the metal tab into the
buckle. There will be an audible “click” when the tab locks into the buckle. Pull up on
the shoulder strap to tighten the lap belt across your hips. The seat belt retractor
will pull in any slack in the shoulder strap. A slow and easy motion will allow the belt
to extend and let you move your body around freely.
Periodically check the seat belt as you ride to be sure it remains snug and in position.
If there is a sudden stop or impact, the belt will lock into position. It will also lock
(restrict) if you try to lean forward too quickly.
If the driver’s seat belt is not fastened when the ignition is switched ON, the
seat belt warning lamp illuminates. Refer to ‘Warning Lamps’ in the ‘Features
and Control’ chapter for further details.
5.8.6 Fastening the Seat Belt (2-Point Lap type)
This seat belt is applicable to the second row middle passenger seat. Insert the
metal tab into the buckle until it snaps. Position the lap belt on the hips as low as
possible.
SEATS AND SEAT BELTS
To Next Page
Loading...
Need help?
General
