Diagnostic Manual ( EMS) LCV MDI BSIII CRDe
Rev 01- Mar 14
All copyrights reserved by
The repair methods given by the manufacturer in this document are based on the technical specifications current at the time of release.
The methods may be modified as a result of changes introduced by the manufacturer in the production of the various component units
and accessories from which the vehicles are manufactured. The reproduction, translation, transmission, in part of whole of the present
document, are prohibited without the prior written consent of 2014 Mahindra & Mahindra Ltd (Truck & Bus Division)
P 0335: Crankshaft sensor – No signal
Possible Causes : Open circuit of the positive or the negative cable
Corrective Action : Check for Open circuit between 2 &15; 1 & 14
P 0336 : Crankshaft sensor signal error.
Possible cause : This error can only come if any teeth signal is missing or
Improper.
Corrective Action : Look for damage on toner wheel teeth damage
P0371: F_M_Aps_crank_early_fault_rec
Possible Cause : This error can only come when the teeth are too close. It is
not expected to happen in a running vehicle.
Corrective Action : If reported check if the flywheel and the toner ring changed
just prior to the failure. Take corrective actions accordingly.
P0372 : Crank signal fault - missing tooth
Possible Cause : This error can only come when the teeth is shifted or missing.
It is not expected to happen in a running vehicle.
Corrective Action : If reported check if the flywheel and the toner ring changed
just prior to the failure. Take corrective actions accordingly.
P0335
P0336
P0371
P0372
To Next Page
Loading...
Need help?
General
