5
Assembly Instructions
NOTE: Please do not fully tighten all bolts until you finish assembling all parts. Once assembled,
go back and fully tighten all bolts. This will make the assembly easier.
1. Unpack the unit and confirm that you have all the hardware and required parts.
2. Locate the Spine Assembly (D) and set the back face down on a scratch-free surface.
3. Fasten the Top Panel (A) to the Spine (D) with two 5/8” Bolts (2) and two Washers (6 and 7).
2
7
6
2
7
6
D
A
UP
D
A
Lock Washer
(2 used in this step)
⑥
Flat Washer
(2 used in this step)
⑦
5/8” Bolt
(2 used in this step)
②
To Next Page
Loading...
Need help?
General