EN 54-16 certified PA/VA System SERIES
56, chemin de la Flambère · 31300 Toulouse · FRANCE · Tél. 33 (0)5 61 31 86 87
Fax 33 (0)5 61 31 87 73 · commercial@majorcom.fr · www.majorcom.fr
User manual V1.1
56, chemin de la Flambère · 31300 Toulouse · FRANCE · Tél. 33 (0)5 61 31 86 87
Fax 33 (0)5 61 31 87 73 · commercial@majorcom.fr · www.majorcom.fr
Usermanual V1.1
4342
SERIES EN 54-16 certified PA/VA System
EOL installation
ϭ Connect the two wires from the end of the speaker lines to the line terminator input.
Ϯ Connect the two output cables of the end of line device to the line of input correspondent to the
“END OF LINE INPUTS”
Installation of the end of line device in a sequence
With a configuration in sequence it is possible to supervise various sections of one line of speakers.
To make a multiple connection, the end of line devices that belong to one same amplification channel,
must be connected in sequence.
ϰϳ VOLUME CONTROLLERS
The device has 8 outputs for volume controls 24V (4-wires). The maximum number of attenuators
that can handle each output must be calculated from the technical characteristics (see chapter 7). The
connection of the end of line devices must be done in parallel, respecting the indicated polarity:
NOTE: After a volume controller, you must not connect an end of line device, as it can cause a failure
detection system of the speaker line.
To Next Page