How to fix abnormal vibration in Makita Trimmer?
Abnormal vibration in your Makita Trimmer can be caused by several factors: a broken nylon cord causing an unbalanced head (bump the nylon cutting head against the ground to feed the cord), a bended, cracked, or worn cutter blade (replace the cutter blade), a loose cutter blade fastening nut (tighten the nut properly), or improper fastening of the cutter blade.
Why does my Makita Trimmer motor stop after a little use?
Your Makita Trimmer motor might stop after a short period of use because the rotation is reverse (change the direction of rotation with the reversing switch), the battery charge is low (recharge or replace the battery), or the tool is overheating (stop using the tool to allow it to cool down).
What to do if cutting tool does not rotate on Makita BBC231U Trimmer?
If the cutting tool of your Makita Trimmer doesn't rotate, it could be due to a foreign object jammed between the guard and the cutting head (remove the object), a loose cutter blade fastening nut (tighten the nut properly), or a bended cutter blade (replace the blade).
Why Makita BBC231U motor does not run?
The motor of your Makita Trimmer might not run due to several reasons: the battery cartridge may not be installed (install it); there might be a battery problem, such as undervoltage (recharge or replace the battery); or the drive system may not be working correctly.
Why doesn't my Makita Trimmer reach maximum RPM?
If your Makita Trimmer does not reach maximum RPM, ensure the battery cartridge is installed correctly as described in this manual. If the battery power is dropping, recharge the battery, or replace it if recharging isn't effective. If the problem continues, the drive system may not be functioning correctly, and you should seek repair from an authorized service center.
What to do if my Makita BBC231U cutting tool and motor cannot stop?
If the cutting tool and motor of your Makita Trimmer cannot be stopped, immediately remove the battery. The cause may be an electric or electronic malfunction.
Why won't the motor run on my Makita BBC231U Trimmer?
If your Makita Trimmer motor isn't running, ensure the battery cartridge is correctly installed. If the battery is low, recharge it or replace it if recharging doesn't help. If the problem persists, the drive system may be faulty, and you should consult an authorized service center for repair.
What to do if the cutting tool does not rotate on my Makita Trimmer?
If the cutting tool of your Makita Trimmer does not rotate, it might be due to a foreign object jammed between the guard and the cutting head or blade. Remove any obstructions. Also, check if the cutter blade fastening nut is loose and tighten it properly. If the cutter blade is bent, it should be replaced. If these steps don't resolve the issue, the drive system may not be working correctly, and you should seek repair at an authorized service center.
What to do if Makita BBC231U cutting tool and motor cannot stop?
If the cutting tool and motor of your Makita Trimmer cannot stop, it indicates an electric or electronic malfunction. Remove the battery and seek repair from an authorized service center.
Crucial safety advice for operation and work environment.
Procedures and precautions before starting the tool's operation.
Procedures for attaching the guard and guard extension.
Steps for mounting the cutter blade and nylon cutting head.
Common malfunctions, their causes, and recommended actions.
To Next Page
General
