5 ENGLISH
NOTE: While charging, the built-in battery and AC
adapter may become warm. This is normal and will
continue until the built-in battery is fully charged and
the AC adapter has been disconnected from the
mains supply.
Tool / battery protection system
The tool is equipped with a tool/battery protection
system. This system automatically cuts off power to
the motor to extend tool and battery life. The tool will
automatically stop during operation if the tool is placed
under one of the following conditions:
Overheat protection
When the tool is overheated, the tool stops automati-
cally. In this situation, let the tool cool before turning the
tool on again.
Overdischarge protection
When the battery capacity is not enough, the tool stops
automatically. In this case, charge the battery.
Switch action
A
B
To start the tool, simply push the switch on the A side
for the clockwise rotation and the B side for the counter-
clockwise rotation. Release the switch to stop.
CAUTION: Always check the direction of
rotation before operation.
NOTICE: Change the direction only after the tool
comes to a complete stop. Changing the direction
of rotation before the tool stops may damage the tool.
Lighting up the front lamp
CAUTION: Do not look in the light or see the
source of light directly.
To turn on the light, press the lamp switch. To turn off
the light, press the lamp switch again.
ASSEMBLY
Installing or removing driver bit
To install a driver bit, push it rmly into the driver bit
holder. To remove the driver bit, pull it out of the driver
bit holder.
OPERATION
CAUTION: When bending the tool to use in
the pistol shape or straightening to use in the
straight shape, do not hold the bendable part of
the tool. Failure to do so may cause your hand and
ngers to be pinched and injured by this part.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
