19
C
Working in winter
In order to prevent carburetor icing in conditions of low tempera-
ture combined with high humidity, and below + 5°C in order to
get up to operating temperature faster, heated air can be taken
from the cylinder.
Remove the Þ lter hood (see „Cleaning air Þ lter“)
Remove the insert (10) and insert it as shown in position B for
cold-weather operation.
At temperatures above + 5°C the carburetor must NOT be fed
heated air. Failure to follow these instructions can lead to
damage to the cylinder and piston!
At temperatures over +5°C place the insert in position A for
normal operation.
Position A
- Normal operation
Position B
- Cold-weather operation
Reinstall the Þ lter hood.
BA
10
11
D
Handle heating
(only DCS6400H, DCS6401H, DCS7300H, DCS7301H,
DCS7900H, DCS7901H)
The electrically heated handles are activated by pushing the
switch (11).
On: red marking on switch visiable
Off: red marking on switch not visiable
To Next Page
Loading...
Need help?
General
