Need help?Do you have a question about the Makita HW 131 and is the answer not in the manual?
General| Brand | Makita |
|---|---|
| Model | HW 131 |
| Category | Pressure Washer |
| Language | English |
Comply with instructions of fitted safety signs. Check presence and legibility.
Appliance designed for individual use for cleaning vehicles, machines, boats, masonry, etc.
Use by unskilled persons or with prohibited liquids is forbidden.
Details safety devices such as safety valve and safety catch.
All installation and assembly operations must be performed with the appliance disconnected from the mains power supply.
Check voltage/frequency. Connect to mains with earth and differential breaker.
Only clean or filtered water. Tap delivery must match pump capacity. Connect close to supply.
Water flow is adjusted by regulating the nozzle (E).
Detergent flow is adjusted using the regulator (F).
Regulator (G) adjusts working pressure. Shown on pressure gauge.
Details starter device (H) for ON/OFF and water jet control lever (I).
Ensure water supply is on, release safety catch, depress trigger, then start appliance.
Apply detergent, let act, rinse with high pressure jet from bottom up, min 30 cm distance.
Disconnect lance, remove dirt deposits from nozzle hole using tool (C1).
Clean suction and detergent filters after every 50 hours of operation.
To Next Page
