What to do if my Makita HW 130 motor fails to start?
If the motor of your Makita Pressure Washer fails to start, make sure the unit is correctly connected to a power source and that the mains voltage supply is present. If that's not the issue, and the appliance hasn't been used for a long time, use the tool to unjam the motor from the hole at the rear of the appliance (in models with this feature).
How to fix Makita HW 130 when the pump does not reach working pressure?
If your Makita Pressure Washer's pump isn't reaching the correct pressure, several factors could be the cause. You may need to replace the nozzle if it is worn. If the water filter is dirty, clean it. Ensure the water supply is fully on. Check all hose fittings to ensure that no air is being sucked into the system. If there is air in the pump, switch off the appliance, depress and release the gun trigger until the water flows steadily, then switch the appliance back on. Finally, check that the adjustable nozzle is positioned correctly.
Why does my Makita HW 130 Pressure Washer pressure drop during use?
If the pressure of your Makita Pressure Washer drops during use, ensure that the appliance is connected to the mains water supply, not an external tank. Also, verify that the intake water isn't too hot; if it is, reduce the temperature. Lastly, check the nozzle for clogs and clean it if necessary.
What to do if Makita HW 130 motor sounds but fails to start?
If your Makita Pressure Washer motor sounds like it's trying to start but doesn't, check that the voltage of the mains power supply line is the same as that on the plate. Also, check the characteristics of the extension cable, as voltage loss may occur due to its use.
General| Brand | Makita |
|---|---|
| Model | HW 130 |
| Category | Pressure Washer |
| Language | English |
To Next Page
