10
The following tables indicate the operating time on a single charge.
ML120
(Note)
If you use a power checking battery on Model ML120, the power checking battery will not indicate the remaining bat-
tery capacity properly.
ML140
ML180
Storing battery cartridge
Always charge the Nickel Metal Hydride battery cartridge
before storing it when you do not use it for more than six
months.
Head angle (Fig. 3)
The head angle can be adjusted in four stages. Adjust as
desired.
Replacing bulb (Fig. 4 & 5)
CAUTION:
The bulb is very hot immediately after operation. Wait
until the bulb cools off before attempting to replace it.
First, turn the ring counterclockwise and remove the
reflector. Then replace the bulb.
Shoulder strap (Fig. 6)
Install the strap on the tool.
MAINTENANCE
To maintain product safety and reliability, repairs, mainte-
nance or adjustment should be carried out by a Makita
Authorized Service Center.
Voltage Battery cartridge Operating time Charger
12 V
1200
1220
1200A
Approx. 110 min.
DC1201, DC1470, DC1411,
DC1422, DC1439, DC1801
1202
1222
1202A
Approx. 160 min.
DC1201, DC1411, DC1422,
DC1439, DC1801
1233 Approx. 190 min.
DC1411,DC1422,
DC1439, DC1801
1234 Approx. 220 min.
1235
1235A
Approx. 260 min.
Voltage Battery cartridge Operating time Charger
14.4 V
1420 Approx. 110 min.
DC1470, DC1411, DC1422,
DC1439, DC1801
1422 Approx. 160 min.
DC1411, DC1422,
DC1439, DC1801
1433 Approx. 190 min.
DC1411, DC1422,
DC1439, DC1801
1434 Approx. 220 min.
1435 Approx. 260 min.
Voltage Battery cartridge Operating time Charger
18 V
1822 Approx. 190 min.
DC1801
1833 Approx. 220 min.
1834 Approx. 260 min.
1835 Approx. 300 min.