Makita PDC01 User Manual (English)

Questions and Answers:

M
mariah03Jul 27, 2025
Why is the Makita PDC01 lamp blinking green?
- S
  Seth CruzJul 27, 2025
  The green blinking light on your Makita Power Pack may indicate a few issues. First, ensure the adapter or power tool/machine plug is securely connected to the battery box socket. If that's not the problem, the batteries may need charging or replacement with charged ones. When using a battery-powered tool or machine with voltage higher than 18V, make sure that at least one battery is installed to battery port 1 or 2, and at least one battery to battery port 3 or 4. It could also mean the unit needs a battery switch, so try switching the tool or machine off and on again, or pressing the power button on the unit. Finally, the cord of the unit might be overheated, in that case you should cool down the unit.
K
Karen MasseyJul 31, 2025
What to do if the Makita PDC01 Power Pack lamp does not light up?
- K
  Kevin CaseyJul 31, 2025
  If the lamp on your Makita Power Pack isn't lighting up, there are a few potential reasons. First, check that the unit is turned on. If it is, make sure the batteries are properly installed. Also, the batteries may be low and need charging or replacement with fully charged ones.
J
Jeff PowersAug 5, 2025
What to do if the Makita PDC01 Power Pack lamp blinks in red and green alternately?
- K
  Karina LucasAug 5, 2025
  If the lamp on your Makita Power Pack is blinking red and green alternately, it indicates the unit has detected an abnormality. Try turning the unit off and then back on.
M
maynardjamesAug 9, 2025
Why Makita PDC01 tool or machine does not start?
- M
  Matthew BanksAug 9, 2025
  If your Makita Power Pack tool or machine isn't starting, it could be due to a few reasons. Make sure the adapters are correctly and securely installed. Also, the tool or machine, or the cords of the adapters might be overheated, so allow them to cool down.
A
Alexandra WilcoxAug 13, 2025
Why won't my Makita PDC01 Power Pack tool start?
- D
  Dr. Amanda RodriguezAug 13, 2025
  Your Makita Power Pack tool might not start for a few reasons. First, the adapters might not be correctly installed; ensure they are securely attached to the tool. Second, the tool, machine, or adapter cords may be overheated; allow them to cool down before trying again. Power off and then power on again.
M
mbestAug 18, 2025
Why is the green lamp blinking on my Makita PDC01 Power Pack?
- D
  danielleconwayAug 18, 2025
  A blinking green lamp on your Makita Power Pack could indicate a few issues. Check that the adapter or power tool/machine plug is securely connected to the battery box socket. It could also mean the batteries don't have enough charge; try charging or replacing them. If you're using a battery-powered tool or machine with voltage higher than 18V, make sure you have at least one battery in ports 1 or 2 and another in ports 3 or 4. Insufficient battery capacity in this configuration can also cause the blinking.